Technical
In production, PBAT & PLA blend blown film grade (carrier, waste & produce bags) relies on a melt that stays stable across a defined temperature window. Consistent melt pressure and even cooling are the two variables that most affect gauge uniformity and optical quality.
Converters generally begin at a moderate screw speed and raise draw-down gradually while watching the bubble or web for neck-in and tear. Because PBAT crystallises differently from polyolefins, the frost line or chill-roll setting should be measured rather than assumed from polyethylene settings.
On the Blown film extrusion route, Pre-blend pellets uniformly and dry PLA-containing compounds before extrusion. Use a gradual temperature profile to protect the PLA phase from thermal degradation. should be expected at line setup. Downstream, sealing temperature and dwell time need to match the film gauge so the finished structure holds without burning or weak seams.
The result is a compostable film that runs on existing equipment without a dedicated line conversion, provided the operating window is established on the first trial rather than copied from a polyolefin grade.
Related Grade
This article refers to PBAT & PLA blend blown film grade (carrier, waste & produce bags), a Carrier & Retail Bags grade supplied as Blown film roll stock. Open the grade page for the full specification and processing guidance.
View the Grade
