Home / Grades / PBAT PLA Thermoforming Film

PBAT PLA cast/flat film & thermoforming grade (shrink, cling & coffee capsule films)

PBAT PLA Thermoforming Film

Product Summary

PBAT PLA Thermoforming Film

A PLA and PBAT cast sheet built for deep-draw thermoforming, including shrink sleeves, cling layers and coffee capsule shells. The blend holds shape after forming without brittle edges.

This grade belongs to the Thermoforming & Cast family, uses a Cast sheet extrusion and thermoforming route, and is supplied as Cast sheet roll for converters serving biodegradable packaging and agricultural markets.

Thermoformed trays, lids, coffee capsules, shrink sleeves and cling layers.

Enquire About This Grade

Specification

Grade Parameters

The table separates format information from resin-level data. Format fields describe how this grade is supplied, while resin values describe the PBAT base where the grade is a pure PBAT formulation.

ModelPBAT PLA cast/flat film & thermoforming grade (shrink, cling & coffee capsule films)
Film FamilyThermoforming & Cast
Process RouteCast sheet extrusion and thermoforming
Supply FormatCast sheet roll
Material BasePBAT / PLA blend
Film quality testing

What Sets It Apart

Grade-Specific Behavior

A PLA and PBAT cast sheet built for deep-draw thermoforming, including shrink sleeves, cling layers and coffee capsule shells. The blend holds shape after forming without brittle edges.

That behavior is achieved through the Cast sheet extrusion and thermoforming route and the PBAT / PLA blend material base, without changing the compostable character of the finished film.

It makes this grade a practical choice for Thermoformed trays, lids, coffee capsules, shrink sleeves and cling layers.

Processing Advice

Processing Recommendations

The following guidance gives a starting point for line setup. Adjust settings against your own equipment and measured film properties.

01Line SetupPre-dry the compound, then form with controlled sheet temperature to avoid web sag. Tune plug and mould temperatures to the draw ratio of the part.
02Material HandlingKeep rolls and compound dry before processing, and avoid prolonged residence time at high melt temperature.
03Quality CheckVerify gauge, seal strength and clarity on the first production rolls before committing the full run.
PBAT PLA Thermoforming Film

Applications

Where This Grade Fits

Thermoformed trays, lids, coffee capsules, shrink sleeves and cling layers.

Its balance of PBAT / PLA blend and process behaviour makes it suitable where biodegradable end of life matters as much as line performance.

For a broader view, compare this grade against the other 1 options in the same family on the applications page.

View All Applications

Packaging & Delivery

How the Grade Arrives

Film is supplied in roll form with the grade name, gauge, width and batch identity marked on each roll. Rolls are protected during transport so the film surface arrives clean and ready for converting.

01Roll FormWound on cores suitable for standard converting equipment, with identity labels on every roll.
02DocumentationEach shipment is accompanied by handling guidance and the grade specification shown above.
03StorageKeep rolls in a dry, shaded area and process within the normal storage life of PBAT film.

Related Grades

Similar Film Grades

These grades share the same film family or process route. Review them side by side when the exact balance of stiffness, clarity or gauge is still open.

20 Micron PBAT Bag Film
20 microns PBAT biodegradable compostable film for making bagsView grade →
PBAT PLA Blown Film Blend
PBAT & PLA blend blown film grade (carrier, waste & produce bags)View grade →
Pure PBAT Blown Film Grade
Pure PBAT blown film grade (carrier bags, garbage bags, mulch film)View grade →

Related Reading

Technical, Knowledge and Commercial Notes

Each grade is supported by three short articles covering processing, material behaviour and application fit. Follow the links below for the full text.