Technical

Technical article

In production, PBAT melt-blown grade (biodegradable nonwovens & filter materials) relies on a melt that stays stable across a defined temperature window. Consistent melt pressure and even cooling are the two variables that most affect gauge uniformity and optical quality.

Converters generally begin at a moderate screw speed and raise draw-down gradually while watching the bubble or web for neck-in and tear. Because PBAT crystallises differently from polyolefins, the frost line or chill-roll setting should be measured rather than assumed from polyethylene settings.

On the Melt-blown nonwoven extrusion route, Run on melt-blown lines with adjusted air temperature and die-to-collector distance to control fibre fineness. Monitor web uniformity during filter media production. should be expected at line setup. Downstream, sealing temperature and dwell time need to match the film gauge so the finished structure holds without burning or weak seams.

The result is a compostable film that runs on existing equipment without a dedicated line conversion, provided the operating window is established on the first trial rather than copied from a polyolefin grade.

Related Grade

This article refers to PBAT melt-blown grade (biodegradable nonwovens & filter materials), a Nonwovens & Filters grade supplied as Melt-blown resin grade. Open the grade page for the full specification and processing guidance.

View the Grade